MB-22 E-Z Polishing Powder For Terrazzo- 1lbs (0.45kgs)

MB-22 E-Z Polishing Powder For Terrazzo- 1lbs (0.45kgs)

The MB-22 E-Z Polishing Powder delivers a stunning shine to terrazzo and calcite-based stone products. It’s easy to use and won’t damage surfaces with splatter. It’s one of the best wet polishes for terrazzo surfaces that delivers a high shine and dazzling gleam. Formulated even for calcite-based stones.

General Directions

Different stones require different polishing techniques. In general, you would need to:

  • Prepare the surface. Hone it to the highest clarity possible.
  • Apply proper masking materials to areas of the surface that can be damaged by splatters.

Below are the specific directions for buffing terrazzo floors and countertops:

    Floors:

    • Target an area of approximately 10 sq. ft. (1m2)
    • In the middle of the target area, sprinkle approximately 2 oz. (50 - 60gms) of product in a circular pattern slightly smaller than the diameter of the floor machine.
    • Using a natural blend pad, position the floor machine with water on top of the powder.
    • The machine cannot exceed 175 RPM for best results and needs at least 1.5 HP.
    • Release 5 seconds of water and swiftly swing the machine back and forth over the targeted area to evenly spread the slurry. (Note: keep the slurry thick; not too wet.)
    • Polish slowly with a spiral motion moving from one end of the targeted area to the other and back.
    • Continue polishing for 3-4 minutes.
    • Then check the surface with a squeegee. You should have a high polish at this point.
    • Next release just enough fresh water onto your target area to make vacuuming the used slurry easy.
    • Then clean with a neutral cleaner such as MB-1 Floor Amore One Step Cleaner.
    • Now repeat this process on next section.

    Countertops:

    • Target an area approximately 4 sq. ft.
    • On the targeted surface, sprinkle 1 tablespoon of product in a circular pattern slightly smaller than the polishing pad you are using.
    • Spray some water on the powder and over the rest of the targeted area.
    • Set the speed of the right-angle grinder/polisher (variable speed is a MUST) to the slowest speed.
    • Using a natural blend pad, move the machine over the targeted area slowly, applying steady pressure.
    • Check the surface for results after approximately 2 minutes.
    • If you have a high polish, semi-flush the section and pull the slurry down to next section and repeat.


    Coverage:


    Depending on the type of stone, expect coverage of approximately 125 – 200 sq ft (12 - 20m2) per pound (0.45kgs)


    Note: Also Available In Carton Quantity Of 6 x 1lbs (0.45kgs)



    image




    Related Items